Springfield Armory : PG-XDS+
XDS/XDE/XDS MOD2 PLUS ONE magazine extension
This unit replaces the magazine base plate on the Springfield XDS/XDE/XDS MOD2 in 45ACP, 40 S&W and 9mm single stack magazines. This extension adds one round capacity to the magazine and increases the grip length by approximately 7/8" inch. The unit also incorporates a texture that matches well with the Mod 2 pattern but still feels good on the earlier frames. This product utilizes the patent pending PearceLock attachment mechanism.
M&P 380 SHIELD EZ: PG-EZ
M&P 380 SHIELD EZ Grip Extension
This unit replaces the magazine base plate on the single stack M&P 380 SHIELD EZ. This extension does not alter the capacity of the magazine. It adds approximately 1/2" inch additional gripping surface with enhanced ergonomics.
M&P SHIELD & SHIELD 2.0 PLUS : PG-MPS+
M&P SHIELD & SHIELD 2.0 PLUS Magazine Extension
This magazine extension for the M&P SHIELD/2.0 replaces the magazine floor plate providing Two extra rounds of 9mm and One round of .40 cal.
It also adds 1" additional gripping surface for better control and comfort while also incorporating the factory texture pattern. The extension uses the patent pending PEARCELOCK mechanism to secure the extension body to the magazine.
*** Will not work on S&W Shield 45 ACP.
GLOCK : PG-FI48
GLOCK 43X & 48 Grip Frame Insert
This unit fits in the bottom rear cavity of a Glock 43X & 48 utilizing a friction fit to secure it in the frame.
Springfield Armory XD MOD.2 45 : PG-M2.45
Springfield Armory XD MOD.2 45 series grip extension
These units replace the factory magazine base plate. They will add approximately 5/8 inch additional gripping surface while incorporating a similar texture to the factory grip. This extension will not alter the capacity of the magazine.
Note: This extension will fit the XDM 45, however the texture pattern across the front of the extension will not match the checkering pattern on this frame.
This unit will NOT fit the single stack Springfield XDS 45
SIG : PG-365
SIG P365 Grip Extension
This unit replaces the magazine base plate on the SIG P365 (10 round magazines). This extension does not alter the capacity of the magazine. It adds approximately 5/8" inch additional gripping surface (1/4" longer than factory extension) as well as enhanced ergonomics. The enhanced griping surface also incorporates a texture which closely matches the frame of the firearm.
GLOCK GEN 5 : PG-G5BP
Enhanced baseplate for GLOCK Gen 5 M19, 17 and 34
Grip Enhancers replace the magazine base plate and retain all other factory components. They do not alter the capacity of the magazine and provide better comfort by filling the semi-circular cut-out in the lower front area of the grip body. This product will only work on magazines equipped with double notches for the ambi magazine release. (Gen 4 & 5 magazines) Fits Gen 5 models 17,19 and 34